Grinderino!
Frame Parts
Umma85/Umma95 - Carbon Clean Plate
#NOTE: These are a small run of made to order kits. Please allow some extra time to ship after your order is placed. I wanted to build smallest dro...
View full detailsThe Remix 5" 5mm Arm Conversion Kit
This kit is for those who prefer beefier arms for those concrete bando sessions. This is everything you need to convert your Remix to 5mm arms. Inc...
View full detailsAcrobrat Duo Base Plate
Spare main plate for your Acrobrat Duo 3" frame. 3mm and chamferred Made from high quality Toray Carbon Fiber. Includes: 1x 3mm main plate
M3 x 5mm Unthreaded Spacer
Lose the unthreaded spacer on your Remix V2? Want a spare just in case? Well you're in luck! We now sell the M3 x 5mm unthreaded spacer on it's own...
View full detailsRemix Frame Replacement Full Hardware Kit (Purple)
Grade 2 Titanium hardware and anodized aluminum pieces. This is all of the sizes standoffs, bolts, washers, nuts, and spacer that makes up a Remix ...
View full detailsV1 Remix Frame Replacement Hatch Sled Kit
Belly flop a bit too hard? Cut the throttle in a panic? Or MAYBE... you've been grinding and sliding so much you wore the sled out (get some 3d pri...
View full detailsThe Remix 6" 5mm Arm Conversion Kit
This kit is for those who prefer beefier arms for those concrete bando sessions. This is everything you need to convert your Remix to 5mm arms on ...
View full detailsThe Remix 6" 5mm Spare Arms (2 Arms)
For those looking for beefier 6" arms. Please note that you will need to modify your existing cam plates by filing out about 1mm worth of carbon m...
View full detailsThe Remix Blue Aluminum Kit
Be different. This kit is everthing you need to color change all aluminum pieces for your Remix frame. Includes: 1x Lipo Catch 2x Session Bards (...
View full detailsRemix Frame Replacement Spare Hardware Kit (Purple)
It's always good to have a few spares on hand. This kit contains a few of each size bolt, standoff, nuts, washer, and pressnuts. Available in gold...
View full detailsThe Acrobrat Electronics HW Pack
M2 hardware to help you build a low profile FC stack and/or mount your runcam split (or Caddx Turtle) board onto your Acrobrat. Includes: 4x m2x5 ...
View full detailsRemix Frame Replacement Receiver Plate
Mount your RX to this plate, that goes underneath your FC stack (in the middle of the frame). INCLUDES 1x Replacement Receiver Mounting Plate fo...
View full detailsRemix V1 Replacement Top Plate
If you broke one of these, you were probably doing something EPIC. Get back in the air with this original Remix Top Plate. *Works with 5mm arm conv...
View full detailsMoongoat O3 Camera Plates
Finally. We have produced an updated camera plate to fit the DJI O3 camera on the Moongoat. This was not without it's challenges, but we think we'v...
View full details